Parameters:
Material: ABS + silicone
Applicable Size: 60mm≤width≤ 87mm
(min: 60mm, max: 87mm)

Installation steps(Air outlet)
Step1: Connecting it to the holder by putting the ball joint into the nut and tightening it into the bolt of the holder
Step 2: Tighten the nut clockwise.
Step 3: Press the air vent clip button, insert it into the car air vent, and release the button to tighten it.
Step 4: Press the two buttons below the clamping arm to open the clamping arm, put the phone into the holder, and then press the phone screen to lock it tightly.

Installation steps(Dashboard)
Step1: Put the ball joint into the nut and tighten it into the bolt of the holder.
Step 2: Fix the base of the suction cup holder at the appropriate position and press the vacuum switch.
Step 3: Turn the knob on the front of the support arm clockwise to adjust the height of the support rod.
Step 4: Turn the knob below the support arm forward to adjust it to180 degrees.
Step 5: Press the two buttons below the clamping arm to open the clamping arm, put the phone into the holder, and then press the phone screen to lock it tightly.